BBV Tx1000 Installation Guide download pdf (Page 2)

Tx1000 Series Telemetry Transmitter Installation Guide Rev-01 B 3 May 2001

Page 2 Total pages 14

TRANSMITTER VARIANTS

The system is available in four main variants:

1. Eight camera inputs and two monitor outputs.

2. Sixteen camera inputs and two monitor outputs.

3. Eight camera inputs, two monitor outputs and 16 alarm inputs.

4. Sixteen camera inputs, two monitor outputs and 16 alarm inputs.

Options are available to allow control of 64 cameras using single keyboard and an EX-4 keyboard expander. Please

contact BBV for further information.

All variants allow the use of two fully independent keypads.

The transmitter is a two-part design: the base unit, which is wall- or rack-mounting; and the keypad. The two are

connected by a video cable and a bi-directional RS232 link.

UNPACKING

Inspect the packaging for signs of damage If damage has occurred, advise the carriers and/or the suppliers

immediately. Unpack the units carefully and check that all the items are present and correct.

SAFETY PRECAUTIONS

All normal safety precautions as laid down by British Standards and the Health and Safety at Work Act (or the

relevant National safety legislation if installing in a country outside the U.K.) should be observed, and servicing

should be referred to qualified service personnel.

INTRODUCTION

The BBV Tx1000 Series transmitters are very simple to use in multi-camera CCTV systems. They are easily installed

into either a new or an existing system.

1 2 3 4 5 6 7 ... 13 14

No comments

BBV Tx1000 Installation Guide Page 2